Different types of gate for injection molding

The narrow and shallow portion of the runner as it enters the cavity is called the gate.

Side gate: This is the most commonly used gate type and is commonly used for mold structures with 2 or more cavities. It is placed at the side of the plastic product. The gate has to be cut manually by a cutter.

Submarine gate: The positioning of this gate is flexible thoughout the sides of the plastic product. It can be placed on the fixed or movable side of the mold but the design has to be thought about carefully so that the product will not be left inside the fixed cavity. The gate automatically cuts itself as the mold opens.

Fan gate: It is commonly used for large and flat plate products. It is placed at the side of the product – same as the side gate. The gate has to be cut manually by a cutter.

Film gate: Similar to fan gate except that it is commonly used for thin and flat plate products.

Pin gate: This is possible for molding multiple cavities or parts. The gate positioning is relatively flexible at the top side of the product. The runner layout is very flexible as well. The mold base structure is complicated because it uses a 3-plate method.

Banana gate: This is not a very common gate. It is used when the visible surface of the product requires no trace of the gate. The gate automatically cuts itself as the mold opens.

Direct gate: The sprue serves as the gate. It is placed on the top side of the product. The gate has to be cut manually by a cutter. This gate type can only produce one part per shot. The molding cost is low because the material from the runner was ellimenated. The injection pressure was reduced due to direct cavity filling. The simple mold structure makes the mold cost lower.

related catagory Die & Mould

Link to this article:Different types of gate for injection molding

Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting:Mold Wiki,Thanks

Author: 122 122