The amount of cutting greatly affects the durability of tools, such as work hardening, cutting force, and cutting heat in the machining stainless steel. Whether the selected cutting amount is appropriate has a direct effect on the cutting effect.
1. Cutting speed Vc:
When machining stainless steel, the cutting speed is slightly increased, the cutting temperature is much higher, the tool wear is increased, and the durability is significantly reduced.
To ensure reasonable tool durability, it is necessary to reduce the cutting speed, which is generally selected between 40% and 60% of normal carbon steel. When drilling or cutting, the cutting speed will be slower due to the rigidity of the tool, heat dissipation condition, cooling effect, lubrication effect, and chip removal condition.
Different types of stainless steel have different machinability and the cutting speed needs to be adjusted accordingly. Generally, austenitic stainless steels such as 1Cr18Ni9Ti have a cutting speed correction coefficient Kv of 1.0, a hardness of 2cr13 or less, and an HRC28 or less. The Kv of martensitic stainless steel is 1.3 to 1.5, and the Kv of martensitic stainless steel such as 2Cr13 having a hardness of 28 to 35 is 0.9 to 1.1. The Kv of martensitic stainless steel such as 2Cr13 having a hardness of HRC35 or higher is 0.7 to 0.8. The Kv of concentrated nitric acid resistant stainless steel is 0.6 to 0.7.
2. Cutting depth ap:
There is a lot of room for roughing, and you must choose a larger cutting depth to reduce the number of tool movements and at the same time avoid contact between the tip and the surface of the blank to reduce tool wear. However, if the depth of cut is deep, care must be taken not to vibrate due to excessive cutting force. The option is ap = 2-5 mm. Smaller cutting depths can be selected for finishing and hardened layers should be avoided. Generally, p = 0.2 to 0.5 mm is used.
3. Feed amount f:
The increase in feed rate is not limited by the power of the machine tool. In addition, the feed amount cannot be increased because the remaining cutting height and chip accumulation amount increase as the feed amount increases.
To improve the quality of the machined surface, lower feed rates should be used for finishing. At the same time, note that f must not be less than 0.1 mm / r to avoid cutting in work-hardened areas, avoid trace feeds, and pay attention to the cutting edge so that it does not stay on the cutting edge. Should be. Cutting surface The cutting amount of machined stainless steel is shown in Tables 4 and 5.
Link to this article：How to set the cutting amount when cutting stainless steel
Reprint Statement: If there are no special instructions, all articles on this site are original. Please indicate the source for reprinting.：Cnc Machining，Thank